DeltaKit Magnetic Flow Sensor Assemblies convert existing weldable piping into a highly accurate, non-obtrusive magnetic flowmeter.

DeltaKit Overview

DeltaKit sensor assemblies convert existing weldable piping, from 2 to 80 in. (50 to 2000 mm), into a highly accurate, non-obtrusive magnetic flowmeter. They are used with a remote 4411e transmitter (see separate data sheet).

DeltaKits are used as spare sensor assemblies for existing flowtubes, or as economic flowmeters using existing weldable piping.

Accuracy:
For 1-20" Pipes
Use 1 sensor for ±2.0% accuracy
Use 2 sensors for ±1.0% accuracy
For larger sizes consult EMCO.

DeltaKit Feature	Benefit
Sensors mount flush with internal pipe diameter and do not obstruct flow	Compatible with pulps, slurries, raw sewage, etc.
Uses exiting weldable pipework (no liners)	Lower initial cost
Patented 4411e AC coil excitation (High coil current & high exciter frequency)	Time constant of 0.03 seconds for batching and stable process control; High signal-to-noise ratio for insensitivity to media noise; Low media conductivity > 0.08 microS/cm
Optional extended electrodes	Outperforms conventional magmeters on media that coat piping surfaces
Field replaceable sensors	Minimizes downtime due to failures and reduces stocking costs associated with spare parts
Inherent redundancy from multiple sensors	Output continues if one sensor fails with 2% - 3% of rate typical accuracy
Sensor reference coils (with 4411e transmitter only)	Output compensated for effects due to magnetic particles (slurries) and ambient/process temperature shifts
Internal grounding electrodes	Grounding rings unnecessary for most installations

Sensor Size	Pipe Size
2"	2"
2"	2.5"
2"	3"
3"	4"
3"	5"
3"	6"
6"	8"
6"	10"
6"	12"
6"	14"
8"	16"
8"	18"
8"	20"

DeltaKit Product Literature

The DeltaKit General Specifications are available for download in PDF format. The Adobe Reader is required to open this file.